Model X (2021+) Wrap Maker

Model X (2021+) wrap template size

Tesla's Model X (2021+) template is 1024 × 1024 pixels — a 1:1 square, like ten of the other eleven templates Tesla publishes. That size is not a suggestion. The template is a flat unwrap of the car's body panels, so every pixel maps to a fixed place on the vehicle. Change the proportions and the mapping still happens — your artwork just arrives distorted.

Tesla accepts PNGs from 512px up to 1024px per side, but there is no reason to go below the ceiling: the image is stretched over an entire car, and a 512px file looks soft in person. Export at 1024 × 1024, keep it under 1 MB, and name the file with 30 characters or fewer — letters, numbers, spaces, dashes and underscores only. Anything outside that set and the wrap tends to fail quietly rather than throw an error. The wrap size guide covers the full rule set.

Is this the right template for your car?

Covers: Model X from the 2021 refresh onward. Tesla ships no template for earlier cars.

How to confirm this is your template:

• Delivered new from 2021 onward, Plaid included — one template covers the range.
• Yoke or round wheel, five, six or seven seats — the body is the same either way.
• Nothing here fits a 2015–2020 Model X: Tesla publishes no template for those cars.

The mistake to avoid: Stretching this template onto an earlier Model X. The pre-2021 car is a different shape, and no amount of nudging in an editor will make the panels agree.

Closely related templates, if the description above does not match your car:

• Model S (2021+) — Model S from the 2021 refresh onward. Tesla ships no template for earlier cars.

No template exists for the pre-2021 Model X

Tesla publishes wrap templates for the Model X only from the 2021 refresh onward. There is no sheet for Model X cars built 2015 through 2020, and no editor — this one included — can invent one, because a wrap has to match the exact panel layout of the body it is going on. Using the 2021+ template on an older car produces a wrap that is misaligned everywhere.

Designing for this body

A graphic that runs across the falcon-wing door line reads as one piece with the doors shut and splits the moment they open. Worth deciding on purpose which of those two views your design is for.

Where this template comes from

Tesla publishes the templates itself, in the teslamotors/custom-wraps repository. The Model X (2021+) sheet lives in modelx-2021/, and the editor above loads that exact file straight from Tesla's repo in your browser. Nothing is rehosted here and nothing you draw is uploaded anywhere — the design stays on your machine until you export it.

Worth knowing: Tesla's own README describes the templates as "512x512 to 1024x1024", which is why so many third-party wrap tools assume a square canvas. The Cybertruck file on disk is 1024 × 768. We read the dimensions from the PNGs rather than the documentation.

After you export

A finished Model X (2021+) wrap goes into Paint Shop one of two ways: through the Tesla mobile app, which needs app version 4.59.0 or later and vehicle software 2026.26 or later, or from a USB drive. The two routes have separate slots — 10 wraps from the app and 10 from USB, not 10 in total. The upload guide walks through both. If the file goes across and then never appears in the car, the troubleshooting page lists the usual causes — an oversized file and an illegal filename character between them account for most of it.